Investigators have recreated in laboratory tests the network overload behind the FAA’s nationwide halt of U.S. departures on November 13, but they still do not know why the routers failed.
People familiar with the investigation said the tests are a step forward in tracing the outage, which stopped U.S. departures for more than four hours. The work is taking place at an L3Harris facility in Florida. Investigators there are examining equipment linked to the incident.
The disruption followed the installation of a new router at an FAA facility in El Dorado, Arkansas. Officials said a surge in connection attempts overwhelmed communications and radar feeds. They have also linked the incident to equipment in Amarillo, Texas.
Officials said that equipment began flooding the network after the Arkansas router was turned on. The FAA has paused installation of the Juniper routers. It has switched off the Juniper routers already installed.
For now, it is relying on older Cisco equipment. Officials say they have found no indication that a cyberattack caused the failure. The precise technical cause remains unknown.
Investigators say identifying the cause is necessary to assess whether other routers in the system used for air-traffic communications could also be at risk.